• Unlimited design possibilities.
• Smooth surface.
• Freezing in a short time.
• Early drying.
• It is easy to prepare and use.
• It spreads spontaneously.
• It has high compressive strength.
• High crack resistance.
• It saves time and labor.

• Vases, flower pots, decorative ornaments in the souvenir sector.
• Thickness between 1-2 cm in all model molds.
• It is used in all models where concrete and plaster appearance is desired.

Surface-Mold Preparation:

The surface must be clean, smooth, solid and free from all kinds of dust, oil, dirt, rust, mold oil, detergent and similar materials and wastes that prevent adhesion. The mold must be wetted before application.

Material Preparation:

Pour 5-5.25 L for Gray and 5.5-6 L for White and Pearl into a clean container with clean water that has been rested at room temperature, preferably at 20°C for 1 – 2 days. Then pour the powder material into the container and mix the mixture with a low speed mixer until a homogeneous mixture without lumps is obtained. The mortar obtained at the end of the process should be poured into the molds within maximum 1 minute. The mortar should be poured into the concrete pot molds with a high, thin and slow flow. Tapping the mold with your fingertips during pouring will help to expel air bubbles for smoother surfaces.

For 25 kg of powder, we recommend the use of 5-5.25 liters of clean water. The demolding time is 15-20 minutes depending on the ambient temperature.

25 Kg